Backhoe Attachment Mechanical Controls Version - New Holland B95C Original Instructions Manual

Backhoe attachment mechanical controls version

Stabilizer mechanical controls
WARNING
Unexpected machine movement!
Before you use the backhoe attachment, make sure that the machine is resting on the stabilizers.
Failure to comply could result in death or serious injury.
Left-hand stabilizer control lever
This lever (A) has three positions:
Position "0": Neutral. This position stops the movement of
the left-hand stabilizer. As soon as the lever is released,
it automatically returns to the neutral position "0" and the
left-hand stabilizer stops raising or lowering.
Position "1": The left-hand stabilizer lowers.
Position "2": The left-hand stabilizer rises.
Right-hand stabilizer control lever
This lever (B) has three positions:
Position "0": Neutral. This position stops the movement of
the right-hand stabilizer. As soon as the lever is released,
it automatically returns to the neutral position "0" and the
right-hand stabilizer stops raising or lowering.
Position "1": The right-hand stabilizer lowers.
Position "2": The right-hand stabilizer rises.
NOTE: To raise or lower the two stabilizers at the same
time, operate the two levers simultaneously.
NOTICE: Before machine travel or before using the
loader attachment, make sure the stabilizers are com-
pletely raised.
Backhoe mechanical control configurations
These control levers are used to operate the backhoe at-
tachment. The speed of movement of each control de-
pends on the angle to which the lever is tilted. In the in-
termediate position, two movements can be obtained si-
multaneously.
Four backhoe attachment control configurations exist,
depending on the country concerned:
• Standard configuration
• ISO configuration
• Four lever pattern configuration
• Cross-pattern configuration
The operating pattern of the control levers is different.
Check which configuration you have on your machine.
3 - CONTROLS AND INSTRUMENTS
3-73
W1326A
1
LEEN12T0556AA