Detent Position For Loader Control Auxiliary Hydraulics - New Holland B95C Original Instructions Manual

Detent position for loader control auxiliary hydraulics

NOTE: Your loader control joystick may not have all options shown.
NOTICE: Continuous hydraulic flow over long periods of time can over heat the hydraulic oil and components.
The switch default configuration is for the switch to spring back to neutral when released from any position. The oper-
ator or a service technician may enable a detent position into the loader control auxiliary hydraulic cycle by adjusting
the roller switch.
The detent position will alter the cycle to allow the operator to roll the switch forward into the detent position. The
detent position will hold open the circuit until the operator rolls the switch out of the detent position.
NOTE: See the attachment manufacturers user guide for operating details. Contact your NEW HOLLAND CON-
STRUCTION dealer for a list of approved attachments.
This control operates the opening and closing of the 4x1
loader bucket clam.
This control is proportional:
When releasing the roller (7), it automatically returns to
the initial position (neutral) and the bucket remains in the
position where it was when movement stopped.
A. When shifting the roller (7) backward: the loader
bucket clam closes.
B. When shifting the roller (7) forward: the loader bucket
clam opens.
Loader control roller detent procedure
Enable the detent position for the switch:
1. Pry off the cap that covers the switch screw.
2. Using a Phillips head screwdriver, remove the screw
(2) that holds the switch (1).
3. Remove the top of the switch (3) .
4. Rotate the top of the switch 180° and start the screw
back into the top of the switch.
NOTE: The open U shape should be to the bottom.
5. Carefully replace the top of the switch and screw into
position. Do not overtighten.
3 - CONTROLS AND INSTRUMENTS
3-59
1
MOLI12LBB0164AB
2
MOLI12LBB0165AB
3
MOLI12LBB0166AB