Table of Contents
Advertisement
STOPPING THE UNIT
Shutting down the engine
NOTE: After you turn off the engine you will continue to hear a clapping or clicking sound this is normal. The Selective
Catalytic Reduction (SCR) system is clearing the Diesel Exhaust Fluid (DEF)/AdBlue® fluid from the tank lines.
NOTICE: Wait 90 s before turning the master disconnect switch to the Off position.
1.
Before you leave the machine, make sure the machine is parked on a level surface. The machine must be on
level ground before you do scheduled maintenance.
2.
Lower the loader bucket to the ground.
3.
Apply the parking brake and place the direction control lever in the NEUTRAL position.
4.
Move the backhoe into the stowed position.
5.
Move the hand throttle to the IDLE position.
6.
Run the engine at idle speed for 2 min (or more if the engine has been working at full load) to cool the engine
parts evenly.
NOTICE: Shutting down the engine when at a higher RPM than idle will damage the turbocharger.
7.
Turn the key switch to the OFF position to shut down the engine. Remove the key.
8.
With the operator's seat in the backhoe operating position, install the backhoe swing lock pin. See 6-31 for more
information.
9.
Position the seat in the driving position.
Parking on a hill
WARNING
Equipment rolling hazard!
Always try to park the machine on firm level ground. Avoid parking on slopes. Block the wheels in
both directions.
Failure to comply could result in death or serious injury.
NOTICE: If you must temporarily park the machine on a hillside, put the front of the machine toward the bottom of the
hill. Make sure that the machine is behind an object that will not move.
4 - OPERATING INSTRUCTIONS
4-15
W0265A
Advertisement
Table of Contents
Troubleshooting
