Shipping Transport; Transporting On A Trailer - New Holland B95C Original Instructions Manual

SHIPPING TRANSPORT

Transporting on a trailer

WARNING
Transport hazard!
The machine can slip or fall from a ramp or trailer. Make sure the ramp and trailer are not slippery.
Remove all oil, grease, ice, etc. Move the machine on or off the trailer with machine centered on the
trailer or ramp.
Failure to comply could result in death or serious injury.
NOTE: The machine shown may be different from your machine. The procedure is the same.
You must know all the applicable rules or laws for safety in each area that you will travel in. Make sure that the truck
and trailer are equipped with the correct safety equipment.
Load the loader backhoe onto a trailer:
1. Park on a level surface.
2. Put a block at the front and rear of the trailer wheels.
3. Put the backhoe in the stowed position.
4. Fasten the seat belt, shift the transmission to first
gear, and slowly drive the machine onto the trailer.
5. Lower the loader bucket onto the trailer, shift the
direction control lever to NEUTRAL, and apply the
parking brake.
6. Release the backhoe from the stowed position.
7. Lower the backhoe bucket or attachment to the floor
of the trailer.
8. Place the transmission in NEUTRAL.
9. Shut down the engine and remove the key.
10. Put a block at the front and rear of each tire of the
loader backhoe.
11. If equipped, make sure all windows are completely
closed and secured.
NOTICE: Wind pressure can break the window
latches or glass.
5 - TRANSPORT OPERATIONS
5-7
W0152A
1
RCPH10TLB056AAF