Fuel System Bleeding - New Holland B95C Original Instructions Manual

Fuel system bleeding

WARNING
Pressurized system!
Only use the bleed screw to bleed air from the fuel system. DO NOT loosen the fuel or injector lines
to bleed air. Injury or damage can occur. Fuel or injector lines are under very high pressure.
Failure to comply could result in death or serious injury.
1. Move the machine to a level and firm ground.
2. Raise the loader attachment and install the safety sup-
port strut.
3. Place the backhoe attachment in the road travel posi-
tion.
4. Place the direction-of-travel lever and gearshift lever in
neutral position.
5. Immobilize the machine by means of the parking brake.
6. Stop the engine and remove the starter switch key.
7. Open and raise the engine tilt hood.
8. From the bottom of the filter, remove the connector (3).
9. Place a container under the prefilter.
10. Open bleed screw (1) on prefilter only and activate
hand primer (2) until fuel flows freely from the bleed
screw.
11. This generally takes 35-45 pumps to fill the fuel lines
and the prefilter.
12. This can be done in about 30 s.
13. Tighten bleed screw.
14. Dry with cloth the prefilter.
15. Connect the electric connector under the prefilter.
16. Start the engine. Engine should start within 5 s.
17. Lower and lock the engine tilt hood.
18. Remove the safety support strut and lower the loader
attachment.
7 - MAINTENANCE
7-128
W0285A
1
LEEN12T0566AA
2
LEEN11T0355AA
3
LEEN11T0370AA