Storage; Machine Storage - New Holland B95C Original Instructions Manual

STORAGE

Machine storage

If the machine is to be in storage for more than 30 days, park the machine inside a building. If a building is not
available, park the machine in a dry area on planks and cover the machine with a waterproof covering.
Geographic, environmental and actual storage conditions make it difficult to follow a set storage procedure for all
areas and conditions. The following procedure is for a storage period of six months or longer. This procedure is a
good starting point but may not be all inclusive. If you have questions about storing your machine, contact your dealer.
1. Inspect the machine for visible signs of wear, break-
age or damage. Order any parts required and make
the necessary repairs to avoid delays when starting the
next operating period.
2. Wash the machine.
3. Lubricate the machine at all grease fittings.
4. Paint any area where the paint has been damaged.
5. Drain the fuel tank.
6. Put approximately 8 l (2 US gal) of diesel flushing oil in
the fuel tank. Run the engine until the exhaust smoke
is blue white.
7. Drain the flushing oil from the fuel tank.
8. Fill the fuel tank and add diesel fuel conditioner by fol-
lowing the directions on the container.
9. Drain the Diesel Exhaust Fluid (DEF)/AdBlue® tank.
10. Move all hydraulic controls to relieve any pressure in
the hydraulic circuits.
11. Change the engine oil and replace the oil filter.
12. Drain the cooling system. Leave the drain valves open
and do not tighten the radiator cap.
13. Put a Do Not Operate tag on the instrument panel.
14. Clean or replace the primary element for the air filter.
15. Cover the exposed cylinder rods, valve spools, and
any other bare metal parts with a rust and corrosion
preventive.
16. Charge the battery. Remove the battery from the ma-
chine and store in a cool dry area where the temper-
ature is above freezing 0 °C (32 °F). Make sure the
battery is clean.
NOTE: Check the battery periodically for the correct electrolyte level. Test the electrolyte with a hydrometer. When
the hydrometer reading is near 1.215, charge the battery.
7 - MAINTENANCE
7-158