Lucent Technologies LambdaXtreme Alarm Messages And Trouble Clearing Manual page 297

TAPs for SYSTEM and PortOther Alarm
Groups
TAP-603: Clear Condition When 'NE
ACTY/INFO-N' LED is Lit
Table 6-2 Determine Command for Condition
Condition to be Cleared
disable alarms-office
alarms
Provisioned Control
Point
Flash removal enabled
test alarm in progress
....................................................................................................................................................................................................................................
365-575-783R1.1
Issue 1, June 2002
Perform Function
Configuration-Alarms-Alarm Configuration
Select the appropriate data and click the
FAULT-Operate Output Miscellaneous Discretes
1. At the CIT, select Fault-Operate Output Miscellaneous Discretes
2. In the Operate Output Miscellaneous dialog box, click on the
Miscellaneous Discrete control point indicated on the Condition
Report description column of the TAP that sent you here.
3. Check the office record to verify if the control point should be ON
or OFF.
4. Click the or
OFF ON
5. Click YES when the system prompts you to confirm the change.
6. Observe that the Output Miscellaneous Discretes
the appropriate condition.
Select
Configuration-Provision
.
pack
1. Click on Provision
Select the appropriate data and click the
2. Click in the confirmation box.
YES
Enable and Disable FlashDisk removal, allows for the replacement of
the FlashDisk. This function allows the user to remove the FlashDisk
from the NCTL circuit pack by pressing the FlashDisk eject button
located on the NCTL circuit pack.
Wait for the test to complete.
Lucent Technologies - Proprietary
See notice on first page
button.
OK
button to change the current setting.
, then click on
Bay->Shelf->NCTL circuit
Apply
Trouble Clearing Tasks
changed to
button
6 - 1 5 7