Lucent Technologies LambdaXtreme Alarm Messages And Trouble Clearing Manual page 206

TAPs for PortOA_RP and LINE Alarm
Groups
TAP-210: Clear APR Active Conditions for
Fiber Disconnects
Procedure
....................................................................................................................................................................................................................................
6 - 6 6
repaired, LambdaXtreme Transport will resume normal operation
and the APR active condition will clear.
............................................................................................................................................................
Examine the NE Alarm List
1
with the failure condition by looking at the alarm source address ID.
............................................................................................................................................................
Remove the appropriate shelf cover. All connections can be accessed
2
from the front. For details, go to
Cover" (7-17).
............................................................................................................................................................
Examine the the entire length of the optical fiber jumper between the
3
RPG port identified in
or RP circuit pack for damage. For details, go to
Optical Fiber(s)"
..........................................................................................................................................................
Examine the
4 NE Alarm List
IF...
YES
NO
............................................................................................................................................................
Remove the identified fiber jumper, and inspect the associated ports
5
on the circuit packs for dirt or damage. For details see
Inspect and Clean Optical Fiber Connectors"
............................................................................................................................................................
Replace the removed fiber jumper with an appropriate replacement.
6
Inspect and clean the connectors on the new jumper before installing
it. For details see
Connectors" (7-11).
..........................................................................................................................................................
Examine the NE Alarm List
7
IF...
YES
Lucent Technologies - Proprietary
See notice on first page
. Identify the appropriate shelf associated
"DLP-607: Remove/Install Front
Step 1 and the corresponding port on the OA
(7-31).
. Is the condition still listed?
THEN...
Continue with
Go to Step
"DLP-606: Inspect and Clean Optical Fiber
. Is the condition still listed?
THEN...
Continue with
Trouble Clearing Tasks
"DLP-609: Inspect
Step 5.
11.
"DLP-606:
(7-11).
Step 8.
365-575-783R1.1
Issue 1, June 2002