TAPs for the SLOT, SHELF, and FAN
Alarm Groups
TAP-107: Clear 'FLASH memory module
code mismatch'
....................................................................................................................................................................................................................................
365-575-783R1.1
Issue 1, June 2002
IF...
NO
............................................................................................................................................................
Important! The CIT will disconnect from the network element when
the FAULT-Reset command is executed. During the reset time, the
miscellaneous discrete control points are deactivated.
At the CIT, select
6
............................................................................................................................................................
Wait 15-30 minutes or until the MJ LED stops flashing. Time to wait
7
will vary depending on system size.
............................................................................................................................................................
At the CIT, view the
8
..........................................................................................................................................................
Is the
9
FLASH Code Mismatch
IF...
YES
NO
..........................................................................................................................................................
Is the correct software release running in a remote network element
10
and is the SUPVY data link good to that network element?
IF...
YES
Lucent Technologies - Proprietary
See notice on first page
THEN...
A fresh copy of the software may have
to be downloaded from a remote NE
or CIT-PC. Continue with
⇒
Admin
System reboot
.
NE Alarm List
condition still listed?
THEN...
Consult the appropriate maintenance
support organization for technical
assistance before proceeding with
other trouble clearing procedures.
STOP! YOU HAVE COMPLETED
THIS PROCEDURE.
STOP! YOU HAVE COMPLETED
THIS PROCEDURE.
THEN...
See the section in the LambdaXtreme
Transport User Operations Guide,
Release 1.1, (365-575-781R1.1)
describing how to copy software from
one NE to another.
Trouble Clearing Tasks
Step
10.
⇒
.
OK
6 - 1 9
™
Need help?
Do you have a question about the LambdaXtreme and is the answer not in the manual?