GBC FusionPunch II Service Manual page 99

REP 2.1 Control Panel LCD
Display PWB
Parts List: 2.1 A
WARNING
Switch off the main power.
Disconnect the Power Cord.
Electrostatic Discharge
The Display PWB is susceptible to
damage from electrostatic discharge. Observe
all ESD procedures to avoid component
damage.
Removal
1. Remove 2 Allen Head Cap screws to
remove Access Plate.
2. Remove 6 Hex Nuts and Lock Washers.
3. Disconnect the LCD Display Connector and
the Keypad Connector.
4. Remove the 4 Allen Head Cap screws from
the LCD Display PWB.
Replacement
1. Reinstall the components in the reverse
order.
NOTE: Make sure that the white wire
on the connector going to the Button
Flat Cable is not connected.
GBC FusionPunch II Service Manual
CONTROL PANEL
COVER ASSEMBLY
CONTROL
PANEL
DISPLAY LCD
CONNECTORS
(2)
HEX NUT (6)
Figure 1.
WASHERS (6)
12/2003
REP 2.1 Control Panel LCD Display PWB
4-3
ALLEN HEAD
CAP SCREWS
(4)
Step 1.