GBC FusionPunch II Service Manual page 128

ADJ 5.1 Stacker O-Ring Roller
Assembly
Purpose
To adjust the O-ring Assembly to prevent jams
in the Stacker and / or poor stacking quality.
Adjust Sequence
1. Remove the Stacker O-ring Assembly
(PL 5.1 C).
NOTE: Keep the washer on the top of
the Stacker O-ring Assembly.
2. Loosen the two screws.
3. Press down and hold the Front Roller.
4. Adjust the O-Ring Roller Ski until the Ski is
at the same height or just below the Roller.
5. Tighten the two screws.
6. Rotate the O-Ring Roller Ski upwards to an
45° angle.
7. Retighten the two screws to ensure that
they do not work loose.
ADJ 5.1 Stacker O-Ring Roller Assembly
WASHER
FRONT ROLLER
O-RING
ROLLER SKI
SCREWS (2)
Figure 1.
12/2003
4-32
STACKER O-RING
ASSEMBLY
GBC FusionPunch II Service Manual