Table of Contents
Advertisement
The New Queue Window will display, as shown in Figure 6-45.
Output Tab
3. Go to the Queue Name field and enter the name of the queue to be setup, as follows:
•
GBC Punch
•
GBCSE
•
For any other finishing device, enter the name as it appears in its Finisher Profile sheet.
4. Click the OutputTab, as shown in Figure 6-45.
The Output Tab Screen will display, as shown in the information that follows. This information consists of Print Queue Setup values for the
following finishing devices:
•
GBC Punch Queue Output (for the FusionPunch II)
•
GBC Short Edge Punch Queue Output (for the FusionPunch II and a Xerox high Capacity Stacker)
•
SBM1/SBM2 Queue Output (for the Signature Booklet Maker)
GBC FusionPunch II Service Manual
Figure 6-45 The New Queue Window
12/2003
6-39
DocuSP 3.xxx Print Queue Setup
Advertisement
Chapters
Table of Contents
