GBC FusionPunch II Service Manual page 281

GP-1 Punch Input Test
1. Press the DIAGNOSTICS key until the LCD displays the Punch Input
screen as shown in the table below.
NOTE: INXX corresponds to the LED on the Punch I/O PWB.
Use the Left or Right Arrows to move the cursor to the desired
input as shown in Table 6-9. When in the Input screen, you can
see the input change states either by covering the input Sensor
momentarily or by placing the cursor under an Input to select it
and then actuating the switch that corresponds to that Input.
Table 6-9 Punch Inputs
Input Sensor Status
P Not Used
I1 1101111111111000
P Not Used
I2 1101111111111000
P INA6 Top Covers
I3 1101111111111000
P INA5 Function 2
I4 1101111111111000
P INA4 Function 1
I5 1101111111111000
P INA3 Cycle Up
I6 1101111111111000
P INA2 Set Signal
I7 1101111111111000
P INA1 Page Signal
I8 1101111111111000
P INB8 Exit Sensor
I9 1101111111111000
P INB7 Punch Sensor
I10 1101111111111000
P INB6 XportSensor2
I11 1101111111111000
GBC FusionPunch II Service Manual
Action to change the Status
Open and close the Top Cover.
Cycle Up signal from the Printer - will
change state every time the printer
starts up.
End of Set signal from the Printer - will
change state on the last page of every
book.
Page signal from the Printer - will
change state on every page of a book.
Put a piece of paper between the Exit
Sensor and the Reflector.
Put a piece of paper between the
Punch Sensor and the Reflector.
Put a piece of paper between the Xport
Sensor 2 and the Reflector.
P INB5 XportSensor1
I12 1101111111111000
P INB4 Enter Sensor
I13 11011111111111000
P INB3 Left Door
I14 1101111111111000
P INB2 Middle Door
I15 1101111111111000
P INB1 Right Door
I16 1101111111111000
Figure 6-4 Punch I/O PWB
NOTE: The values shown in Table 6-9 may not correspond
with the values displayed on the LCD.
12/2003
6-9
Put a piece of paper between the Xport
Sensor 1 and the Reflector.
Put a piece of paper between the Enter
Sensor and the Reflector.
Open and close the Left Door.
Open and close the Middle Door.
Open and close the Right Door.
Input LEDs (may vary in brightness)
GP-1 Punch Input Test