GBC FusionPunch II Service Manual page 107

REP 4.5 Punch Infeed Flat
Belts
Parts List: 4.3 B
WARNING
Switch off the Main Power.
Disconnect the power cord.
Removal
1. Perform REP 4.4, Steps 1 to 7.
2. Remove:
2.1 the Thumb Screw and the Side Guide
(Figure 1).
2.2 the 2 Allen Head Cap screws and the
Block (Figure 1).
2.3 the 2 Allen Head Cap screws and the
Female Latch Assembly (Figure 2).
2.4 the 4 Allen screws in the Deck Plates.
3. Remove the Punch Infeed Flat Belts by
sliding them off the Punch Infeed Deck
towards the back of the machine.
4. Clean the Crowned Rollers with Isopropyl
alcohol.
Replacement
1. Install the new Punch Infeed Flat Belts.
2. Reinstall the parts in reverse order.
NOTE: Ensure that the setscrews in
the Crowned Rollers are properly
tightened on the flat surfaces of the 2
Drive Shafts.
GBC FusionPunch II Service Manual
THUMB SCREW
BLOCK
Figure 1.
12/2003
4-11
FEMALE LATCH
SIDE GUIDE
DIE
Figure 2.
SET
RUBBER DRIVE
ROLLERS (2)
PUNCH INFEED
FLAT BELTS (3)
DECK PLATE
REP 4.5 Punch Infeed Flat Belts