GBC FusionPunch II Service Manual page 109

Continued from Page 4 - 12.
Replacement
1. Replace the Punch Clutch Output Timing
Belt.
2. Reinstall the parts in reverse order.
3. Before reinstalling the Punch Right Panel,
check ADJ 4.4 Punch Clutch Home
Position.
NOTE: Be sure to hold the Front Crank
Arm Block when tightening the Allen
Head Cap screw on the Crank Arm.
Failure to do so might result in damage
to the new Punch Clutch Output Timing
Belt. Check that the Stacker(s) are level
with the Punch and that the Stacker(s)
are resting on the Leveling Pads (see
Section 8 Install Procedure).
GBC FusionPunch II Service Manual
BEARING
COLLARS (2)
ALLEN
HEAD CAP
SCREWS
(2)
WASHERS
(4)
FLANGED
BEARING
Figure 2.
12/2003
4-13
SHAFT
ALLEN HEAD
CAP SCREWS
(2)
WASHERS (4)
FLANGED BEARING
PUNCH CLUTCH
TIMING BELT
ANTI-ROTATION
SCREW
PULLEY
PULLEY
PUNCH CLUTCH OUTPUT
TIMING BELT
REP 4.6 Punch Clutch Output Timing Belt
Figure 3.