GBC FusionPunch II Service Manual page 292

The Finishing Window with the Profile Setup screen displays again, as
shown in Figure 6-20.
NOTE: After entering and/or checking the default values for the
FusionPunch II, you will need to repeat Steps 5 through 9 for
each additional finishing device installed in the system.
On-Line Button
Figure 6-20 The Finishing Window and Profile Setup screen
6. Highlight GBC and click On-Line.
7. Select the On-Line Finishers tab in the Finishing Window.
Host Machine Enablement (DocuSP)
The On-Line Finishers screen displays, as shown in Figure 6-21.
Enable
Button
Figure 6-21 Finishing Window and On-Line Finishers screen
8. Highlight GBC again and then click the Enable button.
9. Select the Finishing tab in the Finishing Window.
12/2003
6-20
GBC FusionPunch II Service Manual