GBC FusionPunch II Service Manual page 423

Installation Procedure
WARNING
Switch off the Main Power.
Disconnect the power cord.
Note: If the FP II is already connected to a host printer, then disconnect it from the host printer and each of FP II's Stackers, prior to installing the DocuColor
6060 / iGen3 Upgrade Kit.
1. Remove the Entrance Panel and both of Rear Panels on the FP II Punch unit. (Figure 8-19)
.
GBC FusionPunch II Service Manual
Entrance Panel
Figure 1-84 Removing the Panels
12/2003
8-21
Rear Panels
Installation Procedure