GBC FusionPunch II Service Manual page 15

FusionPunch II Message
Jam Bypass Sensor Paper has jammed at the Stacker 1 Bypass
Sensor
Jam Bypass2 Sensor Paper has jammed at the Stacker 2 Exit
Sensor
Next Device Faulted The downstream device has an error, or the
Stacker Exit Sensor has failed.
Punch Covers Open The Covers did not actuate one or both of the
IS4 and IS5 Cover Interlock Switches.
Punch Mid Door Open The Middle Door did not actuate the IS2 Mid
Door Interlock Switch.
Punch RightDoor Open The Right Door did not actuate the IS1 Right
Door Interlock Switch.
Punch Left Door Open The Left Door did not actuate the IS3 Left
Door Interlock Switch.
Please Home Stackers The Stacker Tray is not in the home position. Raise the Stacker Tray, then press Reset.
Stacker Running-Wait The Lower/Raise Stacker Switch has been
pressed and the Stacker Tray Motor is
running. Machine will not process any other
commands until motor stops.
GBC FusionPunch II Service Manual
Table 1-3 FusionPunch II Control Panel Messages (Continued)
Meaning
Remove any paper from the Stacker Bypass Exit
Sensor and press Reset.
Use a dry cloth, a Q-tip or a can of air to clean the
Punch Exit Sensor and the Reflector.
Switch on the main power to the Stacker.
Remove any paper from the Stacker Bypass Exit
Sensor and press Reset.
Use a dry cloth, a Q-tip or a can of air to clean the
Punch Exit Sensor and the Reflector.
Switch on the main power to the Stacker.
Call for service
Close the Punch Covers.
Close the Punch Middle Door.
Close the Punch Right Door.
Close the Punch Left Door.
Wait until Stacker Tray Motor has stopped running.
12/2003
1-11
Operator Action Technician Action
If the job was to stack in
Stacker 2, but entered the
Stacker 2 Bypass instead and
jammed there, check LOB6
and LOB7 at P/J22 on the
Stacker 2 I/O PWB. If these
LEDs are lit, go to RAP 3.2
and troubleshoot a failure of
the Front Door Interlock for
Stacker 2.
For all other jams, go to RAP
5.4 Stacker Bypass Jams.
For jams that originate in a
downstream device,
troubleshoot that failure first.
If the jam does not originate in
the downstream device, go to
RAP 5.4 Stacker Bypass
Jams.
Check the downstream
device for failure indications.
If there are no indications of
failure, go to RAP 5.5 Stacker
Exit Sensors.
Go to RAP 3.1 Punch
Interlock Switches
Go to RAP 3.1 Punch
Interlock Switches
Go to RAP 3.1 Punch
Interlock Switches
Go to RAP 3.1 Punch
Interlock Switches
Go to RAPs 5.1 Stacker Full,
Stacker Almost Full and
Stacker Upper Switches &
RAP 5.2 Stacker Tray
Direction
N/A
System Checks