GBC FusionPunch II Service Manual page 325

Host Machine Enablement (DocuColor iGen3)
DocuColor iGen3 Profile Setup and Profiles
This procedure was written to coordinate with DocuSP Version C1.1.5.0.0 (AKA DocuColor iGen3 Version C1.1.5.0.0).
NOTE: In order to setup the Finishing Profiles the DFA module must installed and recognized by the host printer upon boot up.
NOTE: You must first logon as "custact" or higher in order to set up the finishing profiles. The following information is for the System
Administrator or the System Analyst.
1. Go to the Press Status Window, click System, as shown in Figure 6-56. Select Logon from the drop down menu. This will bring up the Logon
Window, as shown in Figure 6-57.
System
GBC FusionPunch II Service Manual
Figure 6-56 The Press Status Window
12/2003
6-53
Host Machine Enablement (DocuColor iGen3)