GBC FusionPunch II Service Manual page 283

GP-1 Stacker 2 Input Test
1. Press the DIAGNOSTICS key until the LCD displays the Stacker
Input screen as shown in the table below.
NOTE: INXX corresponds to the LED on the Stacker I/O PWB.
Use the Left or Right Arrows to move the cursor to the desired
input as shown in Table 6-11. When in the Input screen, you can
see the input change states either by covering the input Sensor
momentarily or by placing the cursor under an Input to select it
and then actuating the switch that corresponds to that Input.
Table 6-11 Stacker 2 Inputs
Input Sensor Status
S2 INC1 Fin. Online
I1 1101101101111111
S2 INC2 Fin. NoFault
I2 1101101101111111
S2 INC3 Fin. NotFull
I3 1011111101011000
S2 INC4 Fin. SheetOut
I4 1011111101011000
S2 INC5 Fin. SetOut
I5 1011111101011000
S2 INB1 Front Door
I6 1011111101011000
S2 INA6 Top Cover
I7 1101101101111111
S2 INC8 Tray Up/Down
I8 1101101101111111
S2 Not Used
I9 1011111101011000
S2 Not Used
I10 1101101101111111
S2 Not Used
I11 1101101101111111
GBC FusionPunch II Service Manual
Action to change the Status
Open and close the Front Door.
Open and close the Top Cover.
S2 Not Used
I12 1011111101011000
S2 INB5 Full Switch
I13 1101101101111111
S2 INB6 Upper Switch
I14 1010111001100111
S2 INB4 AlmostFullSw
I15 1101011100110011
S2 INB8 BypassSensor
I16 1101101101111111
Figure 6-6 Stacker I/O PWB
NOTE: The values shown in Table 6-11 may not correspond
with the values displayed on the LCD.
12/2003
6-11
Manually Activate/Deactivate the
Full Switch.
Manually Activate/Deactivate the
Upper Switch.
Manually Activate/Deactivate the
Almost Full Switch.
Input LEDs (may vary in brightness
GP-1 Stacker 2 Input Test