GBC FusionPunch II Service Manual page 131

ADJ 5.4 Bypass Gate Solenoid
and Gate Fingers
Purpose
To prevent jams as the paper is being directed
to the Stacker or the Bypass.
Check
• Check that the Gate Fingers do not block
the paper path when they are in the lowest
or highest position (Figure 1).
• Check the distance between each Gate
Finger (Figure 2).
Adjust sequence
1. Remove the Stacker Rear Panel.
2. Loosen the Allen screw in the Bypass Gate
Solenoid Spur Gear.
3. Manually raise or lower the Gate Fingers
until they are just below the out-feed slot in
the Punch or Stacker Right Panel.
4. Tighten the Allen screw in the Bypass Gate
Solenoid Spur Gear.
5. Go to Stacker 1 or Stacker 2 Output Test
and activate location:
Stacker # 1
S1 OUTB5 Stacker Gate
013 1000000000000100
Stacker # 2
S2 OUTB5 Stacker Gate
013 1000000000000100
GBC FusionPunch II Service Manual
6. With the Gate Solenoid activated, ensure that the Gate Fingers are above the out-feed slot in
the Punch or Stacker Right Panel.
SPUR GEAR
12/2003
4-35
Figure 1.
12.6
13.6
Figure 2.
ADJ 5.4 Bypass Gate Solenoid and Gate Fingers
3.6
4.6
6.6
8.6
10.6
(INCHES)