GBC FusionPunch II Service Manual page 19

Printer Message
Docutech 61XX displays: Indicates that the printer has lost
communications with the external device.
Jam in area 20 and external
finisher. (Fault Code P12-400)
Docutech 61XX displays: Indicates that a fault has occurred in the
external device.
External Finisher Jam. (Fault
Code P12-401)
Docutech 61XX displays: Indicates that the external device did not
respond within the specified time to a sheet
Jam in area 20 and external
that the IOT sent it.
finisher. (Fault Code P12-403)
Docutech 135 displays: The current job is faulted and requires a
reset.
Clear External Finisher to run
jobs to the Bypass Transport/ The FusionPunch II is not on-line.
External Finisher Not Ready
Docutech 135, 61xx displays: The Stacker is full and requires unloading.
External Finisher Full
Xerox 4xxx Printer displays:
External Finisher Full
Docutech 135, 61xx displays: The FusionPunch II is not in online mode.
Clear External Finisher to run
jobs to the Bypass Transport or
External Finisher Not Ready
Xerox 4xxx Printer displays:
External Finisher Not Ready
Docutech 135, 61xx does not The Host Printer has no error message
recognize the Finisher. displayed or has no External Finisher option.
Xerox 4xxx Printer does not
recognize the Finisher.
GBC FusionPunch II Service Manual
Table 1-4 Printer Control Panel Messages
Meaning
Clear any jams, press Stop/Reset, resume the printer.
Check device profiles are correctly set.
Clear any jams, press Stop/Reset, resume the printer.
Check device profiles are correctly set.
Clear any jams, press Stop/Reset, resume the printer.
Check device profiles are correctly set.
Click on the Printer Icon. Select reset if the reset option
is available.
Press Stop/Reset, then press Online/Offline to ensure
that the FusionPunch II is in online mode.
Unload the Stacker. Start the FusionPunch II in online
mode.
Press Stop/Reset, then press Online/Offline to check
that the FusionPunch II is in online mode. Then, press
Start.
Check that the Profile is loaded in the Printer and set
up correctly.
Contact your System Administrator to verify proper
Host Enablement.
12/2003
1-15
Operator Action Technician Action
Go to RAP 6.2 Printer
Connectivity.
Go to RAP 4.2 Punch Jam
Sensors and troubleshoot a
failure with the PUNCH EXIT
SENSOR.
Ensure that there are no fault
indications at the downstream
device.
If no faults are present on the
downstream device, go to
RAP 5.5 Stacker Bypass Exit
Sensors
Clear any jams, press Stop/
Reset, resume the printer.
Check device profiles are
correctly set.
If the failure continues to
occur, go to RAP 5.5 Stacker
Bypass Exit Sensors.
Go to RAP 6.2 Printer
Connectivity
Go to RAP 5.1 Stacker Full,
Stacker Almost Full and
Stacker Upper Switches.
Go to RAP 6.2 Printer
Connectivity
Enable the Host Printer
System Checks