GBC FusionPunch II Service Manual page 280

GP-1 Stacker 2 Output Test
1. Press the DIAGNOSTICS key until the LCD displays the Stacker
Output screen as shown in the table below.
NOTE: OUTXX corresponds to the LED on the Stacker I/O
PWB. Use the Left or Right Arrows to move the cursor to the
desired output as shown in Table 6-8. The outputs can be turned
on individually by pressing the UP Arrow when the cursor is
under the selected output. In the same manner, the outputs can
be turned off individually by pressing the DOWN Arrow when the
cursor is under a selected output.
Table 6-8 Stacker 2 Outputs
S2 OUTC1 SheetExit
01 0000000000000000
S2 OUTC2 EndSetExit
02 0000000000000000
S2 OUTC3 Cycle Up
03 0000000000000000
S2 OUTC4 Finisher 1
04 0000000000000000
S2 OUTC5 Finisher 2
04 0000000000000000
S2 OUTC6 StackerDeck
06 0000000000000000
S2 OUTC7 Stacker Dir
07 0000000000000000
S2 OUTC8 Stack Oring
08 0000000000000000
S2
09 0000000000000000
S2 OUTB2 StackByPass
010 0000000000000000
S2
011 0000000000000000
S2
012 0000000000000000
GP-1 Stacker 2 Output Test
Not Used
Not Used
Not Used
S2 OUTB5 StackerGate
013 0000000000000000
S2 OUTB6 Offset 2
014 0000000000000000
S2 OUTB7 Offset 1
015 0000000000000000
S2 OUTB8 Stacker Tap
016 0000000000000000
Output LEDs (may vary in brightness)
Figure 6-3 Stacker I/O PWB
NOTE: The values shown in Table 6-8 may not correspond
with the values displayed on the LCD.
12/2003
6-8
GBC FusionPunch II Service Manual