GBC FusionPunch II Service Manual page 418

11. Connect the Bypass Motor Harness to J10 of the Stacker AC/DC
Distribution PWB, then route it through the Stacker Electrical Panel,
then through the hole in the side of the Bypass Motor Cover. Connect
the Bypass Motor Harness to the capacitor and ground as shown in
Figure 8-15.
BYPASS
MOTOR
CAPACITOR
Figure 1-80 Connecting the Bypass Motor Harness
12. Reinstall the Bypass Motor Cover to the Bypass Motor Mounting
Bracket.
13. Loosen the 4 Hex Nuts securing the Bypass Motor and install the
Bypass Motor Timing Belt.
BYPASS MOTOR TIMING BELT
Figure 1-81 Installing and adjusting the Bypass Motor Timing Belt
14. Slide the Bypass Motor up or down until the Bypass Timing Belt
deflects 0.10 in. (2 - 3 mm).
15. Tighten the 4 Hex Nuts.
16. Mount the Top Bypass Motor Pulley Cover (4 Allen Head Cap screws
and 4 Lock Washers) and Bottom Bypass Motor Pulley Cover (2 Allen
Head Cap screws and 2 Lock Washers).
Bypass Kit Installation procedure
BLACK
BROW N
RED
W HITE
BLUE
HEX NUTS (4)
17. Mount the Bypass Exit Sensor Bracket Assembly (2 Allen Head Cap
screws and 2 Lock Washers).
Figure 1-82 Mounting the Bypass Exit Sensor Bracket Assembly
18. Route the Bypass Exit Sensor Harness together with the Stacker
Interlock Harness on the frame and connect it to the Stacker I/O PWB
connector J1.
Figure 1-83 Routing the Bypass Sensor Harness
12/2003
8-16
ALLEN HEAD CAP
SCREWS (2)
LOCK WASHERS
(2)
SENSOR BRACKET
BYPASS EXIT
SENSOR CABLE
GBC FusionPunch II Service Manual