GBC FusionPunch II Service Manual page 317

Host Machine Enablement (DocuColor 6060)
How to review or change DocuColor 6060 Profiles.
1. Select the Features button from the Control Panel.
Basic Features
2. Select the Basic Features Tab, as shown in Figure 6-49.
3. Click the Finishing Module button and the selected Finisher Profile will be displayed in the bottom right corner of the screen, as shown in
Figure 6-49.
4. To Review or change the Finisher Profile or other Finishing Features press the Settings button, as shown in Figure 6-49.
GBC FusionPunch II Service Manual
Figure 6-49 The Basic Features Tab
12/2003
6-45
Note: If this box is not on the display,
then the IOT is not enabled correctly
Finishing
Module
Settings
Finisher Profile
Host Machine Enablement (DocuColor 6060)