Table of Contents
Advertisement
The Device Profile Window will display, with the Properties and Default Limits Tab Screen showing, as shown in Figure 6-38.
5. With the Device Setup Window and the Properties and Default Limits Screen open, you are ready to begin entering Personality Profile values
for the FusionPunch II and the printer you are using.
a. Go to Personality Profiles and use the profile sheets labeled for the DocuTech 61xx to set up the iGen3 or the Docutech 61xx.
b. Enter the values for the Properties and Default Limits.
c. Enter the name and type of the finishing device, for example, FusionPunch II for the name and External for the type.
d. Verify that all of the entered values conform to those in the profile sheet. If they do not, enter the values from the profile sheet.
Note: If you are setting up the profiles for the Docutech 61xx, continue with Step e.
If you are setting up the profiles for the DocuColor iGen3, click OK, and then close the Device Setup Window and go on to Step 6.
GBC FusionPunch II Service Manual
Figure 6-38 The Properties and Default Limits Screen
12/2003
6-31
DocuSP 3.xxx Profile Setup
Advertisement
Chapters
Table of Contents
