Table of Contents
Advertisement
The Finisher Profile Window will close and then you will be back at the Finishing tab screen. The new profile you setup will be displayed under the
External Finishers box at the bottom of the Finishing Tab Screen, with the Status set to Disabled and Online set to Offline, as shown in
Figure 6-42.
Note:
After setting up the profile for the FusionPunch II, you need to repeat steps 1 through 10 for each additional finishing device installed
in the system.
Online
Enable
8. Right click the profile you setup and the select Online from the drop down list, as shown in Figure 6-42.
9. Right click the profile again, but this time select Enable from the drop down list, as shown in Figure 6-42.
GBC FusionPunch II Service Manual
Figure 6-42 The Finishing Tab Screen
12/2003
6-35
DocuSP 3.xxx Profile Setup
Advertisement
Chapters
Table of Contents
