GBC FusionPunch II Service Manual page 421

DocuColor 6006 / iGen3 Kit Installation Instructions
Preparing for installation
WARNING
Do not connect the Power Cord to the Punch and Stacker until
you are instructed.
Electrostatic
Discharge
Certain components in this product are susceptible to damage from
electrostatic discharge. Observe all ESD procedures to avoid
component damage.
Preparing for installation
1. Prepare for installation
a. Inspect all shipments for damage. If significant damage exists,
contact the shipper before proceeding.
b. Compare the contents of the packages and the packing list.
2. Before installing the DocuColor 6060 / iGen3 Upgrade kit, ensure that
Tag # P1 and S1 have been installed in the Punch and each Stacker.
Refer to the Service Manual Section 6 for the Tag Matrix information.
GBC FusionPunch II Service Manual
12/2003
DocuColor 6006 / iGen3 Kit Installation Instructions
8-19