GBC FusionPunch II Service Manual page 405

3. Uncrate the Punch and Stacker(s):
a. Remove threaded fasteners (using ½" box wrench or socket
wrench) holding the cover to the main portion of the box.
b. Lift off cover and set aside.
c. Remove threaded fasteners holding the front (ramped) portion of
the crate.
d. Lift out front (ramped) section from the crate.
Warning:
Ensure that there is adequate space in front of the ramp.
Stay behind the machine when rolling it down the ramp.
Bottom of ramped section has "Male" Hinge, which will
Note:
connect with the "Female" portion of the hinge attached to the
bottom of the front of the crate.
e. When the Hinges are connected, drop the front of the ramped
section to the floor.
f. Slide out the Fusion Punch down the ramp.
Fusion Punch or Stacker is NOT mechanically connected
Note:
to the inside of the crate, they are only held firmly by styrofoam
blocks and will slide out between them once the top and ramp
section are removed.
g. Repeat steps a - f for the Stacker.
4. Remove the Back Panels from the Punch and Stacker.
GBC FusionPunch II Service Manual
12/2003
8-3
Installation