Table of Contents
Advertisement
23. Replace all covers on the Punch and Stackers.
24. Power up the Punch and check that the Bypass is Enabled (GP-1
Enter / Exit Diagnostics Mode Procedure).
25. Enter the Offline mode.
26. Insert some paper into the Manual Paper Feed Tray to ensure correct
alignment and operation.
27. Ensure the correct host and personality profiles are enabled. Refer to
Section 6 General Procedures for more information.
Note: All down-steam devices must be set up for 6180 speed and must
use 6180 profiles regardless of what kind of Host Printer the devices are
connected to.
GBC FusionPunch II Service Manual
12/2003
8-9
Installation
Advertisement
Chapters
Table of Contents
