GBC FusionPunch II Service Manual page 356

A tag will contain the following information:
TAG:1
CLASS:
USE:
MFG SERIAL NUMBERS:
NAME:
PURPOSE:
KIT NUMBER:
REFERENCE:
NOTE: Tag F 99 IOT Kit has to be installed in all DT 61XX that
will be installed together with the Fusion Punch II. (Xerox Kit #
600K67500) This kit enables proper Set and Page Ack (S3 and
S4). C6 and C7 are not supported from the Fusion Punch II at this
time.
Tag Matrix Card location
Shown below, in Figure 6-33, is an example of a Tag Matrix Card that
would be attached to the Punch middle door and the Stacker door of the
Fusion Punch II.
Figure 6-65 Tag Matrix Card
Serial Numbers and Tag Matrix Information
Serial number location
The Fusion Punch II has two different serial numbers, one for the Punch
module and one for the Stacker module, as well as a Xerox serial number
listed below the GBC serial number. Please note, the Xerox serial number
begins with the letter product code (KEW).
They are located next to the Main Power Switch / Circuit Breaker on each
module.
Service History Log Book location
The Service History Log Book is located next to the Matrix Card in the
Punch.
Part numbers
Tag Matrix Card
Service History Log Book
Pocket Folder
12/2003
6-84
#7610236
#1722675
#1722658
GBC FusionPunch II Service Manual