GBC FusionPunch II Service Manual page 424

2. Setting up and the Entrance Panel. (Figure 8-20)
2.1 Remove the 6 Hex Nuts, the 2 Input Baffles, and the Top Entrance Paper Guide from the old Punch Entrance Panel.
2.2 Take the new Entrance Panel (7610621) from the kit and place the Top and Bottom Input Baffles on the mounting studs of the lower Input
cutout.
2.3 Then, place the new Top (7610530) and Bottom (7610531) Entrance Paper Guides from the kit on top of the Input Baffles.
2.4 Mount the Input Baffles and the Entrance Paper Guides using the 6 Hex Nuts you removed from the Original Panel.
2.5 Store the old Entrance Top Paper Guide inside the FP II, this will ensure that the unit can be connected to Docutech in the future, if needed.
2.6 The old Entrance Panel is of no use anymore, it may be thrown out.
.
Lower Input cutout
3. Lower the Swing Frame all the way to the bottom of its tolerance and the reinstall the New Entrance Panel.
Installation Procedure
New Top Entrance Paper Guide
New Bottom Entrance Paper Guide
Figure 1-85 Setting up the New Entrance Panel
12/2003
8-22
Top Input Baffle
Bottom Input Baffle
Top Entrance Paper Guide
GBC FusionPunch II Service Manual