GBC FusionPunch II Service Manual page 130

ADJ 5.3 Tapper Assembly
Purpose
To prevent excessive pressure on the Tapper
Assembly and shingled stack.
Prerequisite
Perform ADJ 5.2 Stacker Tray Stop Position.
Check
Check that the Tapper Assembly is 1 mm, ± ½
mm, above the Stacker Tray when the Tray is in
the maximum vertical position and the Tapper
Solenoid is active.
Adjust Sequence
1. Press "RAISE/LOWER STACKER # 1" (or
# 2 if a second Stacker is installed and
needs to be adjusted) on the Control Panel
to move the Stacker Tray to its maximum up
position.
2. Enter Diagnostics (GP 1), open Stacker Top
Cover and install a cheater in the Interlock
Switch.
3. Go to Stacker 1 or Stacker 2 Output Test
and activate location:
Stacker # 1
S1 OUTB8 Stacker Tap
016 1000000000000100
Stacker # 2
S2 OUTB8 Stacker Tap
016 1000000000000100
ADJ 5.3 Tapper Assembly
4. Loosen the setscrew in the Gear on the Tapper Solenoid.
5. Rotate the Tapper Shaft clockwise (as viewed from the front of the machine) to increase the
gap, or, counterclockwise to decrease the gap.
6. Tighten the setscrew.
7. Deactivate the location.
8. Operate the Stacker to check the adjustment of the Tapper Assembly.
9. Repeat Steps 1 through 8, if necessary.
TAPPER
Figure 1.
12/2003
4-34
TAPPER
SOLENOID
SETSCREW
1 mm, +/- 0.5 mm
STACKER
TRAY
GBC FusionPunch II Service Manual