GBC FusionPunch II Service Manual page 306

The Finisher Profile Window, Properties and Limits Screen will display, as shown in Figure 6-41.
7. Perform the following steps:
a. Go to Appendix A in this Users Guide and locate the profile sheets for the same device as in the previous steps, but this time, with the sheet for
the Finisher Profile - Properties and Limits values.
b. Ensure that all of the entered values conform to those in the profile sheet, and then click OK.
DocuSP 3.xxx Profile Setup
Figure 6-41 The Finisher Profile Window, Properties and Limits Screen
12/2003
6-34
GBC FusionPunch II Service Manual