GBC FusionPunch II Service Manual page 406

Installing the Punch
1. To begin the process of installing the punch, first open the cover of
the printer output and place a single piece of card stock into the paper
path, as shown in Figure 8-1. The paper will be used to align the
punch to the printer for docking.
Figure 1-66 Card Stock in Printer Output.
2. Adjust the punch swing frame assembly such that it is in position to
receive paper through the opening in the punch side cover. For some
printers, this will be the up position. For some, the swing frame
assembly will be angled down to receive input from an opening lower
in the left side cover.
3. The punch is attached to the printer by aligning the male pins on the
punch docking assembly with the female docking assembly on the
printer (Figure 8-2). Without docking it, move the punch into a
position close enough to the printer to allow the card stock to be
aligned with the input to the punch.
Installation
Figure 1-67 Punch and Printer Docking Assemblies.
4. Remove the rear covers from the punch to access the left and right
rear caster adjustment bolts.
5. Using a 1/2 inch wrench, adjust the left front and left rear caster bolts
to align the card stock protruding from the printer with the center (top-
to-bottom) of the input slot on the punch.
6. Maintaining the position of the card stock, perform a rough visual
leveling of the punch by using a 1/2 inch wrench to adjust the front
and rear casters on the left and right side of the punch.
7. Move the punch to adjust the front-to-rear alignment of the card stock
to within the tolerance shown on the Edge Guide Reference Decal on
the left side of the punch.
12/2003
8-4
GBC FusionPunch II Service Manual