GBC FusionPunch II Service Manual page 295

The New Queue Setup Window will display, as shown in Figure 6-26.
Queue
Name
Figure 6-26 The New Queue Setup Window
3. Go to the Queue Name field and enter the name of the queue to be
set up, as follows:
• GBC Punch
• For any other finishing device, enter the name as it appears in its
Finisher Profile sheet.
4. Go to the Extended Options field and select Output, as shown in
Figure 6-26.
The Output Window will display, as shown in the information that follows.
This information consists of Print Queue Setup procedures for the
following finishing devices:
• GBC Punch Queue Output (for the FusionPunch II)
• GBC Punch Short Edge Queue Output (for the FusionPunch II)
• SBM1/SBM2 Queue Output (for the Signature Booklet Maker)
GBC FusionPunch II Service Manual
GBC Punch Queue Output
Extended
a
Options
Fields
d
Output
e
f
g
h
Figure 6-27 The Print Queue Output Window
5. Refer to Figure 6 - 27 above and fill in or choose the fields, as
specified in the table below, for a GBC Punch Queue output.
Item
a
b
c
d
e
f
g
h
12/2003
6-23
Entry
2-Sided (Do not check the override option)
System Specified
Check the Override option
System Specified
Check the Override option
GBC
Check the Override option
Click OK, then OK again in new Queue Setup window
Host Machine Enablement (DocuSP)
b
c