GBC FusionPunch II Service Manual page 21

Punch Component
Document Transport Motor
Punch Motor
Back Gauge Solenoid
Punch Clutch
Stacker Tappers
Offset Solenoids
Stacker Tray Motor
Stacker Bypass Motor (if
installed)
Stacker Bypass Gate
Solenoid (if installed)
GBC FusionPunch II Service Manual
Table 1-7 Test Mode Checkout.
Normal Operation
The Document Transport Timing Belt
moves smoothly without excessive noise.
The Die Pins move up and down.
The Back Gauge Solenoid actuates three
times each second.
The Punch Clutch actuates three times
each second.
The Stacker Tappers actuate three times
each second.
The Offset Solenoids actuate alternately
each second.
If the Stacker Tray is in the maximum
vertical position, the Tray Motor lowers the
Tray one position a second when the Upper
Switch is deactivated.
The Stacker Bypass Motor drives the
Stacker Bypass Assembly Belt.
The Stacker Bypass Gate Solenoid
energizes to direct sheets to the Stacker. It
de-energizes to direct sheets to the Stacker
Bypass.
12/2003
1-17
Corrective Action
Go to ADJ 4.1 Document
Transport Main Timing Belt
Adjustment
Go to Quality RAP 5.6
and ADJ 4.4 & 4.5.
Go to Quality RAP 5.4
or Quality RAP 5.7
Go to Quality RAP 5.6
and ADJ 4.4 & 4.5
Go to Quality RAP 5.5
Go to Quality RAP 5.3
Go to RAP 5.3
Go to RAP 1.2 AC Power to
the Stacker.
Go to RAP 5.4 Stacker
Bypass Jams.
System Checks