GBC FusionPunch II Service Manual page 291

7. Perform the following steps:
a) Go to page 6-27 and locate the page with the profile sheets for
the same device as in Step 5, this time, with the sheet for the
Timings values.
b) Verify that all of the entered values conform to those in the profile
sheet and click OK.
This will bring you back to the Finishing Window, with the Device Setup
Tab screen displayed.
New
Figure 6-18 The Profile Setup Tab Screen
8.
Click on the Profile Setup tab, as shown in Figure 6-18, then click on
the NEW button.
GBC FusionPunch II Service Manual
The Finisher Profile Window, Properties and Limits screen will display,
as shown in Figure 6-19.
Profile Setup Tab
Figure 6-19 The Properties and Limits Screen
5. Perform the following steps:
a) Go to page 6-27 and locate the page with the profile sheets for
the same device as in Step 5, this time, with the sheet for the
Finisher Profile - Properties and Limits values.
b) Verify that all of the entered values conform to those in the profile
sheet and click OK.
12/2003
6-19
Host Machine Enablement (DocuSP)