Table of Contents
Advertisement
.
System Checks
Table 1-5 Punch/Stack Quality Checkout.
Punch/Stack Quality
Problem
Sets do not offset.
Go to Quality RAP 5.3
Trailing Edges of
Go to Quality RAP 5.4
documents are torn,
marked, or creased.
The document stack is
Go to Quality RAP 5.5
shingled
Documents are not
Go to Quality RAP 5.6
punched
Documents are punched in
Go to Quality RAP 5.7
the center of the sheet
Table 1-6 Jam Locations
Jam Location
Punch Document Transport
Go to RAP 4.1 Document Transport Jams
Stacker (not in the Bypass)
If there is no Bypass installed, go to RAP
5.3 Stacker Jams.
If there is a Bypass installed, and the jam is
in Stacker 2 that backs up into the Stacker
1 Bypass, check the LEDs on the Stacker 1
Exit Sensor. Normal conditions are; Green
LED - always lit, Red LED - lit when the
sensor is NOT BLOCKED, extinguished
when the sensor is BLOCKED. If these
conditions do not exist, go to RAP 5.5
Stacker Bypass Exit Sensors.
Stacker Bypass
Go to RAP 5.4 Stacker Bypass Jams
12/2003
Technician Action
Technician Action
1-16
GBC FusionPunch II Service Manual
Advertisement
Chapters
Table of Contents
