Accessory Receptacle/Connector; Switches - Tracker Off-Road 800SX Service Manual

Secondary Coils
CAUTION
Disconnect the injector connectors before performing
the following procedure.
1. Connect the primary ignition coil connector. Remove
the spark plug cap from the spark plug.
2. Connect the spark plug cap to an ignition test plug or
other suitable tool; then ground the tool away from
the spark plug hole. While turning the engine over,
check for sufficient spark.
RESISTANCE
CAUTION
Always disconnect the battery when performing resis-
tance tests to avoid damaging the multimeter.
Primary Winding
1. Remove the connector from the ignition coil; then set
the meter selector to the OHMS position.
2. Connect the red tester lead to one terminal; then con-
nect the black tester lead to the other terminal.
MOD580
3. The meter reading must be less than 1 ohm.
NOTE: Secondary coil resistance checks are not rec-

ommended. An internal diode in the coil prevents
accurate secondary resistance measurements.
Spark Plug Cap
1. Remove the spark plug cap from the spark plug; then
remove the spark plug wire from the ignition coil.
2. Set the meter selector to the OHMS position.
3. Connect one meter lead to the spark plug end and then
connect one meter lead to the ignition coil end.
MOD581
4. The meter must show approximately 5,000 ohms.
112
Accessory Receptacle/
Connector
 NOTE: This test procedure is for either the recepta-
cles or the connectors.
VOLTAGE (Switched)
1. Turn the ignition switch to the ON position; then set
the meter selector to the DC Voltage position.
NOTE: There are three black terminals and three

orange/black terminals that are connected to their
respective colors.
2. Connect the red tester lead to the orange/black wire;
then connect the black tester lead to ground.
3. The meter must show battery voltage.
 NOTE: If the meter shows no battery voltage, trou-
bleshoot the battery, SW. ACC fuse, SW. ACC relay,
receptacle, connector, or the main wiring harness.
VOLTAGE (Constant)
1. Set the meter selector to the DC Voltage position.
2. Connect the red tester lead to the red/white wire;
then connect the black tester lead to ground.
3. The meter must show battery voltage.
NOTE: If the meter shows no battery voltage, trou-

bleshoot the battery, fuse, receptacle, connector, or
the main wiring harness.

Switches

SEAT BELT LIMITER
NOTE: This vehicle is equipped with a speed limita-

tion device to limit the speed if the driver's seat belt is
not fully engaged. The seat belt indicator light will
remain illuminated until the driver's seat belt is fully
engaged.
Resistance
1. Set the meter to the OHMS position.
2. Remove the driver-side rear inner fender. Locate the
switch connector above the fuel tank; then discon-
nect.