Oil Level Stick; Seat Latch; Safety Flag Bracket; Rack Loading (Front And Rear) - Tracker Off-Road 600 Operator'smanual

Oil Level Stick

There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure:

NOTE: The ATV should be on level
ground when checking the engine
oil level.
1. Unscrew the oil level stick and wipe
it with a clean cloth.
2. Install the oil level stick.

NOTE: The oil level stick should
be threaded in for checking pur-
poses.
3. Remove the oil level stick; the engine
oil level should be within the operating
range as indicated.
CAUTION
Do not overfill the engine with oil.
Always make sure the oil level is
within the operating range.

Seat Latch

1. To remove the seat, lift up on the
latch release (located at the rear of the
seat); then raise the rear of the seat
and slide it rearward.
2. To lock the seat into position, slide
the front of the seat into the seat
retainers, line up seat latch and latch
pin and push down firmly on the rear
of seat. The seat should automatically
lock into position.
Make sure the seat is secure before
mounting the ATV. Severe personal
injury may result if the seat is not
properly secured.

Safety Flag Bracket

A bracket is provided for mounting a flag
at the rear of the ATV.
Rack Loading (Front
and Rear)
The front rack and rear rack are designed
to carry specified load capacities. Always
refer to the ATV Load Capacity Ratings
chart for proper capacities.
Make sure the loads on the front and
rear racks will not interfere with the
ATV controls or obstruct the view of
the operator. Also, make sure the
loads are evenly distributed, properly
GZ461A
secured, and will not shift while oper-
ating the ATV.

Trailering and Towing

Never use the racks as a towing or
trailering point.
This vehicle is equipped with a frame-
mounted receiver for a standard 2 in. (5.1
cm) receiver hitch. The standard receiver
hitch must be purchased separately.
OHA010
! WARNING
! WARNING
! WARNING
OHA009
47