container extend mvolume
To extend a multilevel volume set by adding one or more arrays to
it, use the container extend mvolume command. Any file
system on the multilevel volume set remains intact, and can be
extended to include the added space.
Command and Switch Availability
This command is supported on Windows.
Syntax
container extend mvolume
{container} [{container}...]
Parameters
{container_to_extend}
Specifies the ID number (0 to 63) of the array to extend.
Typically, this array is a multilevel volume set.
Specifies the ID number (0 to 63) of the array to add to the
previously specified multilevel volume set. If a file system
exists on this array, the command displays an appropriate
error message and does not allow you to create the multilevel
volume set. This prevents the loss of any data residing in files
on the array.
{container}...
Specifies the ID number (0 to 63) of the array or arrays to add
to the previously specified multilevel volume set. The
previous file system information applies to these additional
arrays as well.
container Commands
{container_to_extend}
3-43