Table of Contents
Advertisement
To exit subcommand mode, press Enter. (You may have to press
Enter more than once to exit subcommand mode.)
I
CLI-unique commands
For NetWare systems, the following commands are unique to
the CLI in that you use these commands when accessing the CLI
from the NetWare server console:
I
open
I
close
I
exit
I
toggle_more
I
Comments—If the first non-blank character on a line in the CLI
is an exclamation point (!), the rest of the line will be ignored.
You can type comments after the exclamation point. This is
particularly useful in scripts where you want to comment out
sections of code.
Command Syntax
You can enter only valid CLI commands at the command line
prompt.
All commands use the following syntax:
[class] action [object] [/switch1[=value1]
[/switch2[=value2]...]] [parameter1 [parameter2...]]
The CLI syntax uses the following conventions:
[text]
{type}
parameter{type} The parameter defined by the value type.
[text...]
Class
CLI commands are grouped according to class. Classes currently
supported include array, controller, diagnostic, disk, logfile, task,
and enclosure and are required except in subcommand mode.
The text element within brackets is optional.
The type specified within braces is the value type
(for example, boolean, integer, string, and so on).
Two or more text elements.
Introduction
1-5
Advertisement
Table of Contents
