Table of Contents
Advertisement
container unlock
!
Caution: Use the container unlock command only
under the direction of Technical Support.
To unlock an array so it can be moved, deleted, made read-only,
and used to create a multilevel array, use the container unlock
command.
Syntax
container unlock {container}
Parameters
{container}
Specifies the ID number (0 to 63) of the array to unlock.
Examples
Before unlocking an array, use the container list command
(with the /full switch) to obtain information about any existing
arrays. As the following example shows, there is an array 0 (a
volume set) on this controller. Note that the Lk column displays an
L, which indicates that array 0 was previously locked with the
container lock command:
AAC0>container list /full
Executing: container list /full=TRUE
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- --------
F: 0
Volume 10.0MB
Note that the example eliminates some items in the container
list display so that you can see an example of the Lk column.
The following example shows how to unlock array 0:
AAC0>container unlock 0
Executing: container unlock 0
Total
Oth Stripe
Size
Ctr Size
Scsi
Usage
C:ID:L
NTFS
0:02:0
container Commands
Lk
--
L
3-112
Advertisement
Table of Contents
