Container Remove File_System - Adaptec AAR-21610SA Reference Manual

container remove file_system

To remove the file system from an array, use the container
remove file_system command. Use this command when the
file system on the array is no longer needed.
This command fails if there are open files on the array.
Command Availability
This command is supported on Windows.
Syntax
container remove file_system {container}
Parameters
{container}
Specifies the ID number (0 to 63) of the array from which you
want to remove the file system.
Examples
Before removing a file system from an array, use the container
list command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 10.0MB
Total Oth Stripe
Size Ctr Size
Scsi
Usage C:ID:L Offset:Size
NTFS 0:02:0 64.0KB:
container Commands
Partition
10.0MB
3-82