Container Remove Drive_Letter - Adaptec AAR-21610SA Reference Manual

container remove drive_letter

To remove a drive letter, use the container remove
drive_letter command. To use the container remove
drive_letter command, none of the array's files can be open.
Command Availability
This command is supported on Windows.
Syntax
container remove drive_letter {string}
Parameters
{string}
Specifies the drive letter to remove. The colon (:) after the
drive letter is optional.
Examples
Before removing a drive letter from an array, use the container
list command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller with a drive letter
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 10.0MB
The following example removes drive letter
AAC0> container remove drive_letter F
Executing: container remove drive_letter "F"
Use the container list command after using the container
remove drive_letter command to display information about
the array on which you just removed a drive letter, as in the
following example:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Volume 10.0MB
Total Oth Stripe
Size Ctr Size
Total Oth Stripe
Size Ctr Size
:
F
Scsi
Usage C:ID:L Offset:Size
NTFS 0:02:0 64.0KB: 10.0MB
from array 0:
F
Scsi
Usage C:ID:L Offset:Size
NTFS 0:02:0 64.0KB:
container Commands
Partition
Partition
10.0MB
3-78