Rear Panel Diagram - Gilson 155 User Manual

Installation

Rear Panel Diagram

1 fuse drawer
2 MAINS power switch Use this rocker switch to apply power to the detector. Once
3 power receptacle
4 remote event/autozero For remote activation of some detector functions.
5 output channels
6 SW1 selector
7 SW2 selector
8 GSIOC
9 RS-232
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Contains the fuses. If it's not already installed, see page 2-4.
the detector is powered on, leave power on to the detector
unless you are performing maintenance procedures. When
the detector is not in use, press the front panel LAMP ON/
OFF key to turn off power to the lamps instead of turning
power off to the detector.
For connecting the power cord to the detector.
For sending three channels of analog data to a recorder or
stand-alone integrator.
For reviewing and changing the unit ID.
For reviewing and changing the baud rate.
Gilson Serial Input/Output Channel, a 2-way
communications link to the computer.
Serial connector, a 2-way communications link to the
computer.
2
2-3