Plumbing Setup; Inlet Tubing - Gilson 155 User Manual

Installation
2-12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Plumbing Setup

The detector arrives with the flow cell, the inlet and
outlet tubing, and the end fittings already in place.
You must make these two plumbing connections:
1 Inlet tubing to your column outlet. See Inlet
Tubing, below, for details.
2 Outlet tubing to another detector or to a back
pressure regulator if effluent is being directed to
a fraction collector or to drain. See
Tubing, on the next page, for details.
The detector accessory packages for analytical,
microbore, preparative, and capillary flow cells
include a back pressure regulator.

Inlet Tubing

Analytical, microbore, preparative, and SFC
Connect the stainless steel inlet tubing to your column
outlet with the Upchurch Fingertight fitting from the
accessory package. This fitting accommodates most
existing female column outlets.
To connect the Upchurch Fingertight fitting, insert
it onto the stainless steel tubing. Screw the fitting
into the column outlet; then finger tighten.
Instructions for replacing the inlet tubing and
fittings are found in Section 4,
2
Outlet
Maintenance.