Table of Contents
Advertisement
2
Installation
RS-232 connection
If the detector is not part of an HPLC system
controlled by Gilson software, the RS-232 port can
be used to transfer information between the
detector and a computer.
Be sure your computer is turned off before making
any connections.
To connect your computer to the detector, you need
an RS-232 cable. Obtain a cable with D-connectors
that are appropriate for the detector and your
computer. The detector requires a 25-pin male D-
connector. Refer to the back panel of your
computer or its documentation to determine which
type of D-connector it requires. RS-232 cables are
available from Gilson and your local computer
store.
See
Appendix D
for a list of commands that can be
issued to the detector via the RS-232 or GSIOC
connection.
2-7
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Advertisement
Table of Contents
