Table of Contents
Advertisement
Maintenance
Attach UV lamp connector and install lamp
housing
1
Attach the UV lamp connector to its socket on
the internal circuit board. The side of the
connector with the curved edge faces you when
you install the connector.
2
Mate the lamp housing with the monochromator
casting. Be careful that the lamp age indicator
does not get between the lamp housing and
monochromator casting.
3
Using the three thumbscrews, secure the lamp
housing to the monochromator casting.
Install visible lamp
1
With the flat edge of the lamp facing upward,
insert the lamp into the lamp housing.
2
Once the lamp is inserted, rotate it slightly in
either direction. Then gently pull on the lamp to
ensure that it's secure.
3
Attach the lamp's connector to the internal
circuit board.
Check out new lamp
1
Close the detector's front door.
2
Plug the detector's power cord into an outlet.
3
Turn on MAINS switch.
4
Press LAMP ON/OFF.
If the lamp fails again, there may be an internal
alignment, a power supply, or a starting circuitry
problem. Contact the Gilson Customer Service
Department or your Gilson representative. See the
Before Calling Us
information on page 5-10.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
4
4-25
Advertisement
Table of Contents
